Allstar Performance is frequently adding new products to our vast line. Check back here to see our latest additions
Switches have male bullet terminals for easy, two-wire hook up. Commonly used with under-floor mounted brake pedal assemblies. ALL76250 is lever actuated with a spring return switch, has two #10-32 tapped mounting holes, 5/8" on centers, and is rated 4.5 Amp. The contacts of ALL76251 close with rising pressure, 60-120 PSI; mounting stem is 11/32" long with 1/8"-27 dryseal thread.
Circuit breakers protect electrical circuits similar to fuses, but cool and reset to maintain power to critical items such as headlights or ignition systems. Use circuit breaker to power accessories in a race car and to keep constant power to ignition. Steel base and mounting bracket provide durability and ease mounting to panels. 10-32 threaded stud terminals include nuts with lock washers.
Fully adjustable gas pedals are available for straight or angled foot box panels. Bronze bushings and nylon rollers provide smooth operation. Linkage arm has .250" diameter holes spaced every 1/2" for adjustment of throttle linkage. Aluminum construction.
Comfortable, lightweight, general purpose safety glasses have a clear wrap around lens for maximum visibility. ANSI-Z87.1 rated.
Fan spacers position fan closer to radiator or fan shroud and away from pulleys. 1.5" - 3" spacers are uniquely designed allowing spacer to remain bolted to water pump while changing fans. Aluminum spacers include reducer bushing, four Allen bolts to secure spacer to water pump and four hex bolts with washers to secure fan to spacer. Note: ALL30180 and ALL30182 include one set of four Allen bolts only.
Tape seals threads on pipe connections. 1/2" x 21 ft. roll.
Protect electrical connections and secure wires. 3/4" x 60 ft. roll.
Tool separates ball joint from control arm or spindle. Inside of cylinder is shaped to fit tapered stud of ball joint.
Remove burrs from damaged or rusted external threads on bolts, spindles, axle tubes, threaded shaft, pipe, and pipe fittings. Choose from three different files, each 8-1/2" long. Standard and metric sizes.
Chassis set-up blocks are adjustable in 1/4" increments. A quick release pin holds block at desired height. Bottom surfaces of blocks are contoured to fit steel tubing or any flat surface and have magnets for holding block to chassis. Short blocks adjust 1.75"-4". Tall blocks adjust 3"-6"